DENAIR

Why do the LEDs flicker at the dim end of the dial?

One row of LEDs behaves beautifully until the dimmer reaches its last few degrees. Then the light trembles across the table. That narrow stretch of the dial tells you something a complaint of “bad bulbs” leaves out.

Example of a flicker pattern confined to the low end of the dial.

Inside each LED lamp, a driver turns the incoming supply into power the LEDs can use. A wall dimmer changes the supply it delivers. At a low setting a particular driver and dimmer may run out of stable operating range together.

The lamp that changed the row

Suppose one lamp was replaced last week. If only the newcomer shimmers, its model is a valuable clue. If the whole row flickers near minimum, the dimmer’s supported load, the mixture of lamps and its low-end setting all deserve a look.

“Dimmable” on a box still leaves open which dimmers the lamp works with. Two lamps with the same wattage and different drivers can behave differently at exactly the same setting.

A better specification for the replacement

Give the installer the lamp model, how many share the dimmer and the part of the range where the light becomes steady. Some dimmers allow an installer to set a supported minimum. The model’s compatibility guidance tells them whether adjustment or a different pairing makes sense.

Read more about choosing a replacement lamp

© 2026 DENAIR. All rights reserved.

DENAIR is operated by BAFOEV TECHNICAL SERVICES L.L.C. Dubai DET License No. 1118204.

DENAIR