Where does the other water from an RO filter go?
Fill a one-litre jug from the RO tap. How much water did the system take from the mains to make it? More than a litre. While some water passes through the membrane towards the tap or tank, a separate stream carries concentrated material to drain.

For this example, three litres enter and one leaves as treated water.
Read the ratio aloud
“Two litres to drain for one litre of treated water” means about three litres entered the system in that example. A quoted ratio can also be written in the opposite order. Have the supplier put the words “to drain” and “to tap” beside the numbers before comparing models.
A tank changes when you hear the water moving. Drawing a glass uses water already in storage. The unit may feed the membrane and send water to drain afterwards while the tank refills. Timing just the few seconds it took to fill your glass misses part of the cycle.
How much will this installation use?
Ask for the model’s tested efficiency and the pressure and operating conditions behind it. EPA’s WaterSense information for point-of-use RO systems gives you a common basis for reading efficiency claims. Then ask the installer to show you where the drain line ends. You will know both what the quoted ratio means and where the second stream goes.
© 2026 DENAIR. All rights reserved.
DENAIR is operated by BAFOEV TECHNICAL SERVICES L.L.C. Dubai DET License No. 1118204.