Why does the toilet refill when nobody has flushed?
A few seconds of running water interrupt a quiet bathroom. The sound stops before anyone reaches the door. If nobody flushed, the fill valve may simply be replacing water that left the cistern between uses. Where could it have gone?

DENAIR illustration. Water can pass the flush valve seal or enter the overflow tube.
Think of the cistern as a small reservoir with a valve at each end. The inlet admits fresh water until the level rises. At the bottom, a seal holds the stored water above the bowl until the next flush.
Two routes into the same bowl
Water slipping past the bottom seal may make barely a ripple. Given enough time, the level drops and the inlet briefly opens again. There is another route if the fill level rises too high. Water can pass over the overflow and run into the bowl that way.
Both faults can leave a thin trickle on the back of the bowl. One detail that helps a plumber is the pattern you hear. Is it a distinct refill every so often, or a steady hiss that carries on between flushes?
With a concealed cistern, that sound and the bowl may be all you can observe. Leave the wall plate in place. Note which toilet it is, how often it runs on its own and whether the sound follows a flush by roughly the same interval.
Once you have reported that toilet, an unexplained change at the water meter is a separate clue worth recording if it continues.
© 2026 DENAIR. All rights reserved.
DENAIR is operated by BAFOEV TECHNICAL SERVICES L.L.C. Dubai DET License No. 1118204.